Antenna Care And Replacement; Electronic Devices; Potentially Explosive Atmospheres; Repair And Warranty - Telular TELGUARD DIGITAL TG-1 Installation And Operating Instructions Manual

ANTENNA CARE AND REPLACEMENT

Do not use the unit with a damaged antenna. If a damaged antenna comes into contact with the skin, a minor
burn may result. Have your antenna replaced by a qualified technician immediately. Use only a manufacturer-
approved antenna. Non-approved antennas, modifications, or attachments could impair service quality,
damage the Telguard and violate FCC regulations.

ELECTRONIC DEVICES

Most modern electronic equipment is shielded from RF energy. However, RF energy from cellular devices
may affect inadequately shielded electronic equipment. RF energy may affect improperly installed or
inadequately shielded electronic equipment operating in homes and businesses. Check with the manufacturer
or its representative to determine if these systems are adequately shielded from external RF energy. Consult
the manufacturer of any personal medical devices (such as pacemakers, hearing aids, etc.) to determine if
they are adequately shielded from external RF energy.
BLASTING AREAS
To avoid interfering with blasting operations, turn OFF your unit when in a "blasting area" or in areas posted:
"Turn off two-way radio." Construction crews often use remote control RF devices to set off explosives.

POTENTIALLY EXPLOSIVE ATMOSPHERES

Turn OFF your unit when in any area with a potentially explosive atmosphere. It is rare, but your Telguard
Digital or its accessories could generate sparks. Sparks in such areas could cause an explosion or fire
resulting in bodily injury or even death. Areas with a potentially explosive atmosphere are often, but not
always, clearly marked. They include fueling areas such as gas stations; below deck on boats; fuel or
chemical transfer or storage facilities; areas where the air contains chemicals or particles, such as grain, dust,
or metal powders; and any other area where you would normally be advised to turn off your vehicle engine.
Do not transport or store flammable gas, liquid or explosives in the area of your Telguard Digital or
accessories.
Vehicles using liquefied petroleum gas (such as propane or butane) must comply with the National Fire
Protection Standard (FPA-58). For a copy of this standard, contact the National Fire Protection Association,
One Batterymarch Park, Quincy, MA 02269, Attn: Publications Sales Division.

REPAIR AND WARRANTY


If trouble is experienced with the Telguard Cellular Alarm Transmission System please contact Telular
Technical Service in the U.S.A. for repair and (or) warranty information.
Telular Security Products
TECHNICAL SERVICES DEPARTMENT
420 Thornton Road, Suite 109
Lithia Springs, GA 30122
Phone: (800) 229-2326

The customer (user) should not attempt any repair to the Telguard Cellular Alarm Transmission System.
Repair of this equipment should be referred to only qualified technical personnel.
iv
56034002 1/9/2006 © 2006 Telular Corporation