Diagnostic And Status Leds; Led Signal Strength Indication - Telular TELGUARD DIGITAL TG-1 Installation And Operating Instructions Manual

2.7 D
IAGNOSTIC AND
Six LEDs are provided as a useful aid during installation and give installers an immediate visual indication of
system status.
LED Function Table – Normal Operating Mode (J10 = OPEN
LED Symbol
LED 6
LED 1
Registration
LED 2
STC
LED 3
MODE
LED 4
Acknowledgement
LED 5

2.7.1 LED Signal Strength Indication

The Telguard provides the installer with an easy to use LED radio signal strength indicator (RSSI) for
positioning the unit or remote antenna to obtain the strongest RF signal possible. A signal strength
reading can be obtained at any time there is power applied to the Telguard without affecting the
operation of the unit. When the "RSSI" jumper J10 is "SHORTED", the Telguard displays the current
received signal strength within 5 seconds. The signal strength is read from left to right using the four
sequential LEDs located on the top right side of the printed circuit board with the Radio TX LED = 5
and the STC LED = 2. See Appendix A1.4 for RSSI table.
56034002 1/9/2006
S LED
TATUS
Color Duty Cycle
RED Solid On
Green Solid On
Off
Flashing
Off
RED
1 Flash*
2 Flashes*
3 Flashes*
4 Flashes*
5 Flashes*
6 Flashes*
Off
Yellow
On
Fast Flash
Red Solid On
Off
Flashing
Green Off
On
Short Flash (1 sec)
Long Flash (2 sec)
4
S
Indication
AC power connected to unit
Unit is registered with the message center and enabled
Unit not registered with message center (and disabled)
Unit is registered but disabled
ALL OK
System Trouble Condition – Low/Missing AC Power
System Trouble Condition – Low/Missing Battery Condition
AND/OR Battery Charger Failure
Not used
System Trouble Condition – NSC
System Trouble Condition – RFC
System Trouble Condition – DTF
Mode 2, Cell Priority (normal operation)
Mode 1, N/A for TG-1
C/C off-hook to transmit signals over cellular.
Telguard TG-1 waiting for acknowledgement from
Communication Center
Idle state
When flashing with LED 1 unit has failed registration due to the
programming of the panel, CALL TECH SUPPORT
TG-1 initialized
TG-1 initializing & registering with cellular network or
Transmitting Alarm Data
Radio receiving message
Radio sending message
)
© 2006 Telular Corporation