A2.0 Operational Quick Reference Table - Telular TELGUARD DIGITAL TG-1 Installation And Operating Instructions Manual

A2.0 Operational Quick Reference Table

Telguard Event
Typical C/C Alarm Cycle over Telco
ACFC – AC Fail
Condition
LBC - Low Battery
STC
Condition
NSC – No Service
Telguard
Condition (Low
System
Signal Strength)
Trouble
RFC – Radio Failure
Conditions
to Communicate due
to: RFC1: No Link
Request ACK.
OR
RFC2: No Link
Termination ACK.
DTF - Dial Tone
Failure
Not Active for
Cellular alarm
Transmission
CF - Catastrophic
Failure
Automatic Self-Test
Telguard Remote Query –
Communication Center Activated by
Customer Service.
Telguard Enable and Configuration
Upload –
Disable TX – Communication Center
Activated.
56034002 1/9/2006
LED Relay
Response Output
None None
Yes If Selected
AC Power off
and
STC flashes 1
time.
Yes If Selected
STC flashes 2
times.
Yes If Selected
STC flashes 4
times.
Yes If Selected
STC flashes 5
times.
Yes Yes
STC flashes 6
times.
Yes Yes
LED 5 off.
None Yes
Yes None
Radio TX
When
transmitting
Yes None
Radio TX
When
transmitting
Yes None
Radio TX
When
transmitting
Yes Yes
Radio TX
When
transmitting.
15
Radio
Message
None Monitors Telco line voltage and C/C
attempts
None Switch to standby battery if present,
monitor battery, monitor AC for
restoral.
None Wait for LBC restoral, charge battery.
None Continue to validate signal strength,
remove NSC when signal returns
None Wait for RFC restoral.
Yes Internal 30V supply circuit failure.
Return unit for repair on RMA.
None Telguard will not function until
operating parameters are downloaded
to the Telular Communication Center
None Telguard not working.
Yes Send Self-test information to central
(Self-test)) station via Communication Center,
return to ready state
Yes Send Status data to Communication
(Status data) Center for review customer service
Configuration Telguard sends setup configuration to
Data the Communication Center and
(Setup data) switches to READY state to begin
operation. Mode LED turns on and
STC LED turns off.
Yes TX capability is disabled until further
(Status data) notice. Telguard can still receive radio
signals from Communication Center.
© 2006 Telular Corporation
Internal Action