Table of Contents
Advertisement
A1.2 J
ACK AND
Jack
Connects
Designation
J7
Digital Dialer
input/output
C/C Digital
of host C/C.
Dialer
A1.3 T
ERMINAL
Terminal
Definition
Strip Pin
1 STC
Supervisory
Relay Trip
2 STC
output for
programmable
trouble
conditions.
Normally closed
3 NC
No connection
4 NC
5 - Battery
12V Backup
6 +Battery
battery Input
8 AC
AC power
9 AC
input.
12 VAC, 10VA.
56034002 1/9/2006
P
A
IN
SSIGNMENTS
Pin
To
Assignment
1 = Brown R1
2 = Gray
4 = Red R (Ring)
5 = Green T (Tip)
7 = Blue
8 = White T1
S
P
A
TRIP
IN
SSIGNMENTS
Connects
To
Enables transmission of programmed supervisory
trouble code:
24-hour trip
zone input on
•
host C/C.
•
•
•
•
120 VAC
60Hz un-
Provides primary operational power to Telguard and
switched
battery charging circuit.
circuit.
Function
Connects C/C digital
dialer input/output
through unit.
Function
AC Power Fail (ACFC).
AC failure detected at 102 VAC.
Low/Missing Battery Condition (LBC) due to:
Low Battery detected at 11.6 VDC.
Radio Communications Failure (RFC) due to:
Failure to receive Ack after 3 attempts.
Loss of Telguard Dial Tone Voltage (DTF)
due to: Improper dial tone voltage. ≤ 20 VDC.
No Service Condition (NSC) due to:
Received Signal Strength ≤ -114 dBm.
13
Status LED
Reference
MODE LED will flash
when C/C is
communicating over
cellular
Status LED
Reference
When fault condition
occurs:
AC Power LED OFF
STC LED Flashes 1
time.
STC LED Flashes 2
times.
STC LED Flashes 5
times.
STC LED Flashes 6
times.
STC LED Flashes 4
times.
AC Power LED ON
when AC is normal.
AC power LED OFF
And
STC LED Flashes 1
time when AC is low
© 2006 Telular Corporation
Advertisement
Table of Contents
