Connect Power to a PA-220 Firewall
How to Connect Power to a PA-220 Firewall
The following procedure describes how to connect power to a PA-220 firewall.
To avoid injury to yourself or damage to your Palo Alto Networks
that resides on the hardware, read the
STEP 1 |
Remove the screw and star washer from the ground point on the back of the firewall.
STEP 2 |
Crimp a 14AWG ground cable to a ring lug (cable and lug not included), place the ring lug
over the screw and star washer, then replace the screw to aach the cable to the firewall.
Torque the screw to 25 in-lbs and then connect the other end of the cable to earth ground.
STEP 3 |
Connect the DC connector from the power adapter into the PWR 1 port on the firewall and
ghten the connector nut to secure the cable to the firewall.
Ensure the power adapter itself is appropriately posioned (see
STEP 4 |
Plug the AC connector from the power adapter into your AC power source. Aer power is
connected, the firewall powers on as indicated by the green power LED next to the PWR 1
port. The front PWR LED shows green when a funconing power adapter is connected.
STEP 5 | (Oponal)
Connect the DC connector from a second power adapter (purchased separately)
into the PWR 2 port and plug the AC connector into an AC power source.
Connect the second PA-220 power adapter through a different circuit breaker to
provide power redundancy and to allow for electrical circuit maintenance.
PA-220 Next-Gen Firewall Hardware Reference
Product Safety
Warnings.
32
hardware or the data
®
Install the PA-220
Firewall).
2021 Palo Alto Networks, Inc.
©