Table of Contents
Advertisement
INSTALLING QUICK RELEASE BRACKETS
ELMO PTC-400C
Mounting plate for this unit is included in the housing
packet. Remove existing mounting plate installed in the unit
before proceeding.
2539 Mounting Plate:
Attach camera using these (4) holes
1. Place the camera onto the quick release bracket using
the (4) metric 3M Phillips head screws provided with the
kit.
½"
1"
2. The Elmo PTC-400C camera requires 3.5" of spacing for
optimal position within the housing. Use (4) 2" spacer(s),
plus (4) 1" spacer(s) and (4) ½" spacer(s) provided in the
(2) hardware packets.
3. Place (3) 8 x 32 x s Phillips head screws on the top
of the spacer as shown above. Be sure to place the
screws so that they line up with the open slots on the
mounting plate.
2"
4. Slide the mounting plate with camera into position on
top of spacers. Secure 3 screws and captive fastener.
- -
Advertisement
Table of Contents
