I/O Menu; Display Type - QuadTech 1865 Instruction Manual

2.6.3 I/O Menus
Setup
The second of the three main menus is I/O, shown in Figure 2-16. Each function controls
measurement results or instrument I/O interface and is described in detail in paragraphs
2.6.3.1 through 2.6.3.6.

2.6.3.1 Display Type

Setup
Allows selection from four different modes of measurement display, Resistance,
Current, Pass/Fail or No Display. In resistance mode the 1865 instrument will display
the measured value of resistance of the device under test. In current mode the 1865
displays the current to the device under test. In Pass/Fail mode the actual measured value
is displayed in small font along with a pass or fail based on the measurement limit
entered, which could apply to either resistance or current.
Operation
I/O Utilities
Display Type
>>
Result Format Sci Eng
RS-232 >>
IEEE >>
Handler Off On
Results to Floppy >>
Figure 2-16: I/O Menu
Utilities
I/O
Display
Resistance
Current
Pass / Fail
No Display
Figure 2-17: Measurement Display
Page 45 of 87