QuadTech 1865 Instruction Manual page 62

Command
CONFigure:
VALid?
SAVe:
DUPLicate
NEW
RECall filename
FVALid?
FSAVe:
DUPLicate
NEW
FRECall filename
HANDler (state)
VOLTage value
TCHarge value
TDWell value
TMEasure value
TDIScharge value
MODE
RANGe
AVERage
LIMit value
FRESult
DISPlay type
SONPass
RVALid?
RTOFloppy:
DUPLicate
NEW
APPend
CLOSe
Page 62 of 87
Table 2-5: IEEE and RS-232 Commands
Function
Is filename valid to save?
Save setup as duplicate filename in battery
backed up RAM
Save setup as new filename in battery
backed up RAM
Recall setup filename from battery
backed up RAM
Is filename valid to save?
Save setup as duplicate filename on floppy xxxxxxxx
Save setup as new filename on floppy
Recall setup filename from floppy drive
Turn handler port OFF or ON
Set the voltage to value
Set the charge time to value
Set the dwell time to value
Set the measure time to value
Set the discharge time to value
Set the mode to
Set the range to
Set # to average
Set the limit to value
Set the result format to
Set display type to
Stop on pass
Is results filename valid?
Results to floppy
Save results as duplicate filename on floppy xxxxxxxx
Save results as new filename on floppy
Append results to existing filename
Close results of filename
Parameter(s)
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
0 (OFF) 1 (ON)
0000.000
000
000
000
000
A (Auto) M (Manual)
Auto 1mA 100uA
10uA 1uA 100nA
10nA 1nA
000
floating point number
S (Scientific)
E (Engineering)
R (Resistance)
I (Current)
P (Pass/Fail)
N (No Display)
000
xxxxxxxx
xxxxxxxx
xxxxxxxx
xxxxxxxx
Operation