QuadTech 1865 Instruction Manual page 23

Table 1-1: Front Panel Controls and Indicators (Continued)
Reference Name
Number
Figure 1-1
5 MENU
6 CNCL
7 ENTER
8 START
9 POWER
10 OPTION
11 STOP
12 TEST
12a FAIL
12b PASS
13 Caution High Voltage
Introduction
Type Function
Green Push Button Press to enter menu display mode or press
to exit sub menu & return to main menu.
Gray Push Button To exit menu mode with no parameter
changes made or to exit current field
Gray Push Button To switch user to entry mode or to accept
menu entry as entered.
Green Push Button To initiate the measurement
Black Toggle To apply power to the instrument:
Switch 1 = ON, 0 = OFF
3 ½ " Floppy Drive To store test setup conditions and
measurement results. High Density (HD:
1.44M) or Low Density (LD: 720k)
compatible floppy drive. Floppies should
be double sided and formatted for DOS
compatibility.
Red Push Button To stop the measurement (terminate high
voltage at the output terminals)
Indicate P/F Measurement Result based on
preset limit
Red LED When lit in
value is below the set minimum value
(resistance limit).
When lit in
value is above the set maximum value
(current limit).
Green LED When lit, in
value is above the set minimum value
(resistance limit).
When lit in
value is below the set maximum value
(current limit).
Red LED When lit, indicates presence of High
Voltage at the output terminals.
Resistance Mode, the measured
Current Mode, the measured
Resistance Mode, the measured
Current Mode, the measured
Page 23 of 87