QuadTech 1865 Instruction Manual page 71

"FLOPPY SEEK ERROR"
"FLOPPY WRITE FAULT"
"GENERAL FAILURE, FLOPPY"
"HANDLER PORT FAILURE"
"HARDWARE TIMER FAILURE, REBOOT"
"INVALID CALIBRATION CODE"
"INVALID LIMIT"
"INTERNAL HARDWARE FAILURE,
REBOOT"
"LIMIT INVALID, SET TO NONE"
"LOW BATTERY VOLTAGE"
"MAXIMUM # OF SETUPS REACHED"
"NO CALIBRATION DATA FOUND"
"NO IEEE 488 INTERFACE"
"NO INTERLOCK SIGNAL"
"NO PASSWORD ENTERED"
"NO SETUP DATA FOUND"
"NO ZERO DATA FOUND"
"PASSWORD DID NOT MATCH"
Operation
Floppy option not present, defective or disk
not inserted
Floppy option not present, defective or disk
not inserted
Floppy option not present, defective or disk
not inserted
I/O port malfunction during power up
Hardware malfunction during power up
Entered calibration code is invalid
Entered limit is invalid
Hardware malfunction during power up
No limit is accepted (out of range or
invalid)
Memory backup battery, low voltage
(setups and instrument zero could be lost)
Maximum number of files have been stored
Calibration required (refer to ¶ 5.4)
Unit does not include IEEE 488 Option
Open interlock connection at rear panel I/O
Port
Password entry canceled, re-enter
Memory backup battery has been
disconnected, reset time and date
Unit requires zeroing (Refer to Utilities
Menu, ¶ 2.6.4.3)
Incorrect password entered
Page 71 of 87