Page 2
MUST CHECK BEHIND BUMPER FOR ANY METAL BRACKETS OR INTERNAL BRACES BEFORE DRILLING The use of Rydeen Parking Sensor system should never replace normal operational and safety precautions needed for reversing a vehicle. Caution should always be taken in ANY vehicle operation.
Page 3
4) Spray and paint 3) Place the sensors inside the paint mask box (provided). Apply a thin coat of paint. Let it dry then paint again for better paint coating coverage. (For BF450PM) Paint the plastic rings together with the sensor heads.
Page 4
For a Truck 4. Front Sensor Installation 1) The proper placement of the sensors is important both for appearance and for the proper operation of the unit. Sensors should be mounted at 90° angles to the ground. It is important to avoid obstructions caused by bumper shape. 2) Measure the height on a bumper for proper installation locations.
Page 5
4. Front Sensor Installation (Continued) For both BF470P and BF450PM, it is recommended to place the two front sensors at the two front corners of a vehicle. Height should be between 20 to 32-inch and it is the best to place 2 sensors (sensor A & D) at 45-degrees location for the front corners distance detection.
Page 6
22-second after releasing the pedal. Front 6. Technical Support Contact Info If you have other questions about the RYDEEN Parking Sensor Products, please contact your retailer or Technical Support: • Telephone: 1-877-777-8811 (within USA only) •...
Page 7
(Parking Sensor Systems) only to the original purchaser as described by the following: Warranty Period Rydeen warrants this product for a period of one (1) year from the original purchase date. Warranty Coverage This warranty covers all defects in material and workmanship except as specified below.
Need help?
Do you have a question about the BF-450PM and is the answer not in the manual?
Questions and answers