Advertisement
Section 2 Fuselage Assembly
Locate the left and right fuselage, four landing gear
reinforced rods (1*10*206mm x 2, 1*10*305mm x 2),
two landing gear cover and one motor mount.
Apply foam glue to the pre-cut slot at the bottom of
the fuselage.
Apply the glue to the inter-locking joining areas of the
landing gear cover.
Join the fuselage with the landing gear reinforced
foam and allow the glue to properly bond.
Apply foam glue to the pre-cut slot of the fuselage.
Slide landing gear reinforced rod into the slot.
7
Advertisement
