Advertisement
You will need four 9g servos. They are not included.
Must be purchased separately.
Use the blade to cut the slot of servo extension. The
depth is about 5-6mm.
Apply foam glue to the pre-cut slot on the wing.
Slide the servo into the servo mounting plate.
Then put the servo into the slot and secure the servo.
Repeat the same steps for the other 3 servos.
Locate two 2*28mm aileron carbon fiber pushrods,
two 2*31mm aileron carbon fiber pushrods, eight Z-
bend, four heat-shrink tubing, four screws, two
aileron arms.
4
Advertisement
