Related Manuals for Elite Models 39in Sky Sprite
Summary of Contents for Elite Models 39in Sky Sprite
- Page 1 39in Sky Sprite Kit and PNP Versions Specifications Wingspan:39.3 in (1000mm) Length:39.3 in (1000mm) Flying Weight: 760g...
- Page 2 Dear Customer, Congratulations on your purchase of Sky Sprite kit from Value Hobby. We thank you for your generous support, and hope you enjoy your new airplane. At Value Hobby, we hope to offer competitive prices, good performance, and products that you can setup and use with ease. That’s why we extensively researched and tested this airplane, and suggested all the products necessary for you to setup properly.
- Page 3 Before Starting Assembly Unpack your airplane and examine the components. Check for damage of any kind. If you see any damage, please contact Value Hobby immediately. Airframe Parts 1. Fuselage 2. Left and right wing 3. Carbon fiber tube 4. Propeller 5.
-
Page 4: Recommended Equipment
7. Landing gear rod 8. Wheel and wheel housing 9. Landing gear foam 10. Elevator EPO foam 11. Wing EPO foam 12. Part bag 13. Fuselage wing 14. Foam safe glue RECOMMENDED EQUIPMENT Product Quantity FrSky Taranis Q X7 Transmitter FRY-RC-5938 GForce Elite Series 2200mAh 3S LiPO FLM-LP-1874... - Page 5 KIT version only: Secure the control horn on the Locate a landing gear rod, a PU tire, a screw and a aileron with three screws. wheel housing. Use a M2.5*12mm screw to secure the landing gear Insert Z-bend wire into the hole of control horn rod, the tire and the wheel housing together.
- Page 6 Use the 8*300mm tube to put the wing on the Locate the foam stopper for the elevator and secure it fuselage. And secure it with aM2*20mm screw. on the tail. KIT version only: Install a 9g servo into the pre-cut slot on the tail of fuselage.
- Page 7 Secure the control horn on the elevator with three KIT version only: Connect your motor to your ESC. M2.5*16mm screws. Insert the Z-bend wire into the hole of the servo arm. On the control horn, secure the ball link with a M2*10 screw and M2 nut. Install the prop on the motor.