Advertisement
Connect the elevator servo to the 185mm pushrod,
and then to the elevator control horn. The process is
the same as on the rudder. The elevator and the
horizontal tail should be properly aligned.
Locate the four black EPP foam wheels, two white EPP
foam wheels, wooden accessory sheet, a string, and
two wheel bolts (M2*60mm).
Peel one wood wheel core from the accessory sheet.
Apply the glue to the wood wheel core.
Align the hole of the wood wheel core to the hole of
the white EPP foam wheel. Then secure them
together using glue.
Apply the glue to the black foam wheel and the other
side of the white wheel.
Slide the black wheel into the wooden wheel. And
wait for the glue cure. Use another wood wheel core
and black wheel on the other side of the wheel as
shown below.
Locate the landing gear support pieces.
20
Advertisement
