Advertisement
Secure the radial motor mount to the wood motor
mount.
Connect the motor to the ESC.
The ESC power cable goes through the hole on the
fuselage bottom you cut earlier.
The power wire of your brushless motor might not be
long enough to go through the fuselage cover. You
can either leave the ESC under the fuselage cover
after you glue on the cover or use an extension wire.
Using an extension wire would allow you to more
easily change your ESC.
Connect the power to check whether the rotation
direction of the motor is correct. If it is reverse
rotation, two power cables of the motor and the ESC
should be swapped.
Apply glue on the triangle foam support.
Apply glue along the edge of the fuselage and wood
support frame.
13
Advertisement
