Advertisement
Tail installation
Locate a horizontal tail, a vertical tail, two elevator
SFG, two foam triangular rods, two
fiber rods (1*6*200mm x 1, 1*6*230mm x 1).
Apply the glue to the elevator carbon fiber rods.
Secure the 1*6*230mm rod to the horizontal tail's
slot. Secure the 1*6*200mm rod to the elevator's slot.
Apply the glue to the slot of the
them to the pre-cut slot of the
elevator carbon
SFG. Then secure
horizontal tail.
Apply the glue to the pre-cut slot of the elevator
control horn.
Slide the control horn into the slot.
Use the blade to cut a slot of control horn on the
foam. The position of the slot is 1 3/4in from the
rudder bottom and at the leading edge of the rudder.
The slot is 40mm.
15
Advertisement
