Advertisement
Apply the hot melt glue to secure the wheel
nut
Repeat the same steps for both wheels.
Locate the two vertical tail support rods
(2mm*165mm).
Install the support rod on the horizontal tail so that it
meets the end of the carbon fiber rod buried inside.
Secure the support rod with glue.
Glue the other end of the support rod on the vertical
tail.
The CG should be 83mm (3.26in) from leading edge of
the wing.
Control Throws
Extreme & 3D
Ailerons: approx. +/-40 degree
Rudder: approx. +/- 40 degree
Elevator: approx. +/-40 degree
Beginner & Sport
Aileron: approx. +/- 20 degree
Rudder: approx. +/- 20 degree
Elevator: approx. +/- 20degree
23
Advertisement
