Audio Dubbing - Sony Handycam DCR-PC7E Operating Instructions Manual

Audio dubbing

You can record an audio sound to add to the original sound on a tape by connecting
audio equipment or a microphone. If you use the VMC-LM7 adaptor (not supplied) to
connect the audio equipment, you can add a sound on your recorded tape by specifying
starting and ending points. The original sound will not be erased. You can only operate
with the Remote Commander.
RK-G128 connecting cable (not supplied)
:
Signal flow
When using an external microphone, connect it to the MIC jack of the VMC-LM7
adaptor.
If you record the sound using the built-in microphone, you do not need to connect the
VMC-LM7 adaptor.
Notes on audio dubbing
• A new sound cannot be recorded on a tape already recorded in the 16-bit mode (32
kHz, 44.1 kHz or 48 kHz).
• When an external microphone is not connected, the recording will be made through
the built-in microphone of the camcorder.
• A new sound cannot be recorded on a tape already recorded in the LP mode.
• If you add a new sound on a tape recorded by other camcorder (including DCR-
PC7E), the sound quality may become worse.
Audio equipment
VMC-LM7 adaptor
(not supplied)
DCR-PC7E
LINE OUT
3-858-632-12E (E32)
45