Installing The Battery Pack - Sony Handycam DCR-PC7E Operating Instructions Manual

Charging and installing the battery pack

Installing the battery pack

(1) Set the BATT LOCK/RELEASE switch to RELEASE.
(2) Remove the battery terminal cover.
(3) Align the hooks of the battery pack with the catches of the camcorder and
place the battery pack in place.
(4) Set the BATT LOCK/RELEASE switch to LOCK.
1 3
2
4
To remove the battery pack
Follow the procedure above and in step 3, remove the battery pack. When removing the
battery pack, be careful not to drop it.
Note on battery terminal cover
To protect the battery terminals, install the battery terminal cover after the battery pack
is removed.
Note on BATT LOCK/RELEASE switch
Be sure that the BATT LOCK/RELEASE switch is set to LOCK when the battery pack is
installed. Otherwise, it may drop out when you use the camcorder.
To prevent malfunction
In the following cases, make sure that the POWER switch is set to OFF first.
• Installing and removing the battery pack.
• Inserting and ejecting a cassette.
8
DCR-PC7E 3-858-632-12E (E32)