Sony Handycam DCR-PC7E Operating Instructions Manual page 46

Audio dubbing
Recording an audio sound on a recorded tape
(1) Insert your recorded tape into the camcorder.
(2) While pressing the small green button on the POWER switch, set it to VTR.
(3) On the camcorder, press · to set it to playback mode, and then locate the
point where the recording ends by pressing 0 or ). Then press P to set it
to playback pause mode.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
MEMORY indicator flashes and the end point of the recording is stored in
memory.
(5) On the camcorder, locate the point where the recording should begin by
pressing 0 or ). Then press P to set it to playback pause mode.
(6) Press AUDIO DUB on the Remote Commander.
(7) Press P on the camcorder and at the same time start playing back the audio
you want to record. The new sound will be recorded in stereo 2. The recorded
sound in stereo 1 is not heard.
The recording stops automatically near the counter's zero point. Press p to set the
camcorder to stop mode.
You can add the sound not using zero set memory function.
To change the end point
Press ZERO SET MEMORY on the Remote Commander so that the ZERO SET
MEMORY indicator disappears and begin from step 3.
To play back the new recorded sound
Adjust the balance between the original sound (stereo 1) and the new sound (stereo 2)
by selecting AUDIO MIX in menu system.
46
DCR-PC7E 3-858-632-12E (E32)