Returning To A Pre-Registered Position - Sony Handycam DCR-PC7E Operating Instructions Manual

Returning to a pre-registered position

Using the Remote Commander, you can easily go back to the desired point on a tape
after playback.
(1) During playback, press ZERO SET MEMORY at the point you later want to
locate. The counter shows "0:00:00" and "ZERO SET MEMORY" appears on
the LCD screen or in the viewfinder.
(2) Press p when you want to stop playback.
(3) Press 0 to rewind or press ) to fast-forward the tape to the counter's zero
point. The tape stops automatically when the counter reaches approximately
zero. "ZERO SET MEMORY" disappears and the time code appears.
(4) Press ·.
1 ZERO SET
MEMORY
2
STOP
Notes on the tape counter
There may be a discrepancy of several seconds from the actual time or time code.
Notes on ZERO SET MEMORY
• When you press ZERO SET MEMORY, the counter's zero point is memorized. Press
ZERO SET MEMORY again before step 3 to cancel the memory .
• Zero set memory may not function when there is a blank portion between pictures on
a tape.
• Zero set memory functions in recording standby mode.
40
0:12:34
0:00:00
ZERO SET
MEMORY
3
REW
4
PLAY
DCR-PC7E 3-858-632-12E (E32)
FF