Advertisement
褲耳布料安裝方法
1. 穿褲耳前，電源開關為ＯＮ，按下 LK1900A
操作面板 " 準備鍵⑤ "。
2. 褲耳穿過褲耳限位架①。
3. 褲耳穿過褲耳調整器②，碰到鍊輪③，手推
褲耳不放。
4. 按下 " 再送帶④ "，送出一截褲耳後，此為餘
料，在按一次 " 再送帶④ "，裁切完後即為所
設定尺寸。
③
⑤
P6
All manuals and user guides at all-guides.com
LOOP MATERIAL INSTALLATION
METHOD
1.Before loop installed, power switch are ON,
press operation panel button ⑤ ".
2.Loop go through loop limit rack ① .
3.Loop go through loop adjuster ② , engaged
with sprocket wheel ③ , push the loop
constantly.
4.Press "feed-again ④ ", It will feed a section
of the loop as left over Press "feed-again ④ "
after cutting, it will be final setting size.
①
②
④
Advertisement
