Point Hitch (Cat. Ii, Iii, Or Iiin) Set-Up - MacDon R80 Operator's Manual

f. Secure pin with clevis pin (F), washers, and
cotter pin.
g. Assemble PTO driveline male half (G) onto PTO
shaft (H) on APT. Push male half so that PTO
shaft is at its fully compressed length.
h. Locate PTO shaft in hook (J).
Form # 169053
OPERATION
F
G
J
H
6.3.4 3 Point Hitch (Cat. II, III, or IIIN) Set-
Up
L
a. Attach the 3 point hitch yoke (K) to the APT with
pin (L). The installation is similar to that
described in the previous section.
b. Secure pin (L) with clevis pin (M), washers, and
cotter pin.
c. The arms (N) on APT yoke can be set up to suit
the tractor hitch arms:
N
CATEGORY II or IIIN
O
1. Remove pins (O) from arms.
2. Remove arms (N) from APT yoke.
3. Re-install arms on opposite ends of yoke as
shown.
4. Re-install pins (O) in arms.
20
M
K
CATEGORY III
(continued next page)
Model Year - 2010