Maintenance Schedule; Break-In Inspection - MacDon R80 Operator's Manual

7.13 MAINTENANCE SCHEDULE

The following maintenance schedule is a listing
of periodic maintenance procedures, organized
by service intervals. Regular maintenance is the
best insurance against early wear and untimely
breakdowns. Following this schedule will
increase machine life. For detailed instructions,
refer to the specific headings in Section 7,
Maintenance/Service.
lubricants specified
Recommended Fluids and Lubricants.
Service Intervals:
intervals are in hours of operation.
service interval is given in more than one time
frame, e.g. "100 HOURS OR ANNUALLY",
service the machine at whichever interval is
reached first.

7.13.1 Break-In Inspection

HRS
1 Wheel Bolts
Drive Belts
5
Hardware
25
Drive Belts
Drive Belts
Cutterbar Lubricant
50
Bevel Gearbox Lubricant
Pump Gearbox Lubricant
100
Hydraulic Oil Filter
Bevel Gearbox Lubricant
150
Cutterbar Lubricant
250
Cutterbar Lubricant
Form # 169053
MAINTENANCE/SERVICE
Use the fluids and
in Section 7.3.1
The recommended service
Where a
BREAK-IN INSPECTIONS
ITEM
Recommended intervals are for average
conditions. Service the machine more
often if operated under adverse conditions
(severe dust, extra heavy loads, etc.).
CAUTION
Carefully follow safety messages given
under Section
SERVICING,
RECOMMENDED SAFETY PROCEDURES.
Torque 120 ft·lbf (160 N·m)
Tension
Torque. Refer to Section 7.3.2.
Tension
Tension
Use only specified amount. Do not overfill.
Change.
Change
Change
Change
Change
111
IMPORTANT
7.1 PREPARATION
and Section
CHECK
Model Year - 2010
FOR
7.2