Machine Assembly At The Customer; Commissioning; Aggregation To A Tractor - Farmet DV-400C/4000NS Operating Manual

Manual
CRUMBLING ROLLER DV 400C/4000-8000 NS

2. MACHINE ASSEMBLY AT THE CUSTOMER


The operator must perform the assembly according to the instructions of the producer, best in cooperation with
the expert servicing technician determined by the producer.

The operator must secure a functional test of all assembled parts after the completion of the machine
assembly.

The operator must secure that the handling of the machine using lifting equipment during its assembly is in
accordance with chapter "C".

3. COMMISSIONING


Before taking over the machine, test and check, whether damage occurred during transport and whether all
parts contained in the bill of delivery were supplied.
 Before commissioning the machine, carefully read this operating manual, especially Chapters A-D p. 4-9.
Before the first use of the machine, familiarise yourselves with its controls and overall function.

During work with the machine, observe not only the instructions of this operating manual, but also generally
valid regulations of work safety, health protection, fire and transport safety, and environmental protection.

The operator must check the machine before every use (commissioning) from the standpoint of completeness,
work safety, work hygiene, fire safety, transport safety, and environmental protection.
A machine showing signs of damage must not be commissioned.

Aggregation of the machine with the tractor is to be performed on a flat and hardened surface.
 When working on slopes, observe the lowest allowable slope grade of the set TRACTOR - MACHINE.

Before starting the tractor motor, check whether no person or animal is in the working space of the set and
push the warning sound signal.
 The operator is responsible for the safety and all damage caused by the operation of the tractor and the
connected machine.
 The operator is obliged to adhere to the technical and safety regulations of the machine determined by the
producer when working.

When working with the machine, the operator(s) must observe the prescribed speed according to the Manual,
Table 2.

The operator is obliged to lower the machine to the ground and secure the set against movement before
leaving the tractor cabin.
3.1.

AGGREGATION TO A TRACTOR

 The machine can be connected only to a tractor, whose curb weight is identical or higher than the overall
weight of the connected machine.
 The machine operator must observe all generally valid regulations of work safety, health protection, fire
safety, and environmental protection.

The operator may connect the machine exclusively to a tractor that is equipped with a rear three-point
suspension and a functional undamaged hydraulic system.

The table of requirements for the towing means for work with the machine:
11 │ 25