LG CLOi UV-C Bot User Manual page 8

Table of Contents

Advertisement

8
Before Use
y The robot may fail to recognize or avoid thin and long obstacles (banners, guide posts, etc.)
and collide into them. For safe traveling, remove such obstacles from the robot's travel pat
h.
- Failure to do so may cause an accident due to a traveling error or mis-detection of obst
1
acle.
y Using a lamp other than the one recommended by LG may generate ozone. For product pe
rformance and safety, only use a component recommended by LG. (Philips TUV 36W/ G3
6 T8)
y LG is not responsible for any problems that occur when using a product other than the door
sensor provided by LG..
y To detect that people and animals enter the sterilization workspace, install a door sens
or inside the door and proceed with UV processing.
y If there are multiple doors, lock all doors except for the door where the door sensor will
be installed, or if the door cannot be locked, install door sensors on all doors.
yBATTERY
y Read all safety warnings and instructions. Failure to follow the warnings and instr
uctions may result in electric shock, fire and/or serious injury.
y Prevent unintentional starting. Ensure the switch is in the off position before connecting
to the battery pack, picking up or carrying the robot. Carrying the robot with your finger
on the switch or energizing an robot that has the switch on invites accidents.
y Do not use a battery pack or robot that is damaged or modified. Damaged or modified batte
ries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
y Follow all charging instructions and do not charge the battery pack or robot outside of the t
emperature range specified in the instructions. Charging improperly or at temperatures ou
tside of the specified range may damage the battery and increase the risk of fire.
y Never use the battery, adapter, or charging station from other robots with this robot. Use
only the battery and the charging station provided by LG Electronics.
y Never use the battery, adapter, or charger from this robot with other robots.
y Under abusive conditions, liquid may be ejected from the battery. If this happens, avoid c
ontact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the battery may cause irritation or burns.
y Do not disassemble, remove or short-circuit the battery.
y Do not apply heat or shock to the battery.
y Have the battery replaced when it is no longer able to hold a charge.
y When disposing of this robot, follow regulations for disposal of rechargeable lithium- ion
batteries.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CLOi UV-C Bot and is the answer not in the manual?

This manual is also suitable for:

Rdiim10

Table of Contents