LG CLOi UV-C Bot User Manual page 49

7 Set the intensity of UV processing. You can
select the UV processing intensity level
from [Normal] , [High].
[NORMAL]
It takes about 15 minutes for UV
processing of a 25 square meter space.
[HIGH]
UV processing ability is higher than NORMAL
mode. It takes about 30 minutes for UV
processing of a 25 square meter space.
,
Note
y Press [ ] (Previous) to move back to the
previous screen.
8 Before starting UV processing, install the
door sensor on the door handle and press
[OK].If the door sensor is turned off or not
paired, the guidance screen is displayed as
shown below.
9 Press [Start].
The UV processing-ready screen will
appear.
The robot waits for the set amount of
time to allow the user and all other
persons to exit the target space before
starting UV processing.
Operation 49
4