Advertisement
9.
Sub-assembly B
Sub-assembly B
You have currently built the basis for a 2 person unit. For each additional person on
the unit repeat steps 3 - 6 to build an additional sub-assembly B.
For example:
3 person = build 1 additional sub-assembly.
4 person = build 2 additional sub-assemblies.
etc.
11.
Tap the top of the 650w/850w (module dependent) back panel (B) of the new
sub-assembly B from step 9 with a cushioned mallet to fully engage as shown above.
Tie the 650w/850w back panel (B) to the 3-way junction (D) using a bottom
connector link (Z) (see step 2 for method).
DEN.Booth Assembly Instructions
C
1000w Module = 650w Back Panel
1200w Module = 850w Back Panel
D
3-Way
Junction
(90°)
A
825d Module = 650w Side Panel
1225d Module = 1050w Side Panel
10.
D
3-Way Junction (90°)
Attach the 650w/850w (module dependent) back panel (C) of the new sub-assembly
B from step 9 to the 3-way junction (D) as shown above (see step 1 for method).
12.
Repeat steps 10-11 for every additional sub-assembly made in step 9 then continue
to step 13.
See above for examples of what you should have if you are assembling a 3 person or
4 person configuration.
C
1000w Module = 650w Back Panel
1200w Module = 850w Back Panel
Sub-assembly B
3 Person
4 Person
DWG No: SASS-0040
Revision: B (09/12/15)
Drawn by: Jkb
Drawn date: 06/01/15
Advertisement
