Advertisement
1.
Sub-assembly A
A-1
825d Module = 650w Side Panel
1225d Module = 1050w Side Panel
Insert the modular screws in the 650w/1050w (module dependent) side panel (A-1)
into the keyholes in the 2-way junction (B-1), making sure that all of the screws have
engaged into the keyholes.
3.
Sub-assembly B
C-1
1000w Module = 650w Back Panel
1200w Module = 850w Back Panel
Attach the 650w/850w (module dependent) back panel (C-1) to the 3-way junction (D)
as shown above (see step 1 for method).
DEN.Booth Assembly Instructions
B-1
2-Way Junction (90°)
D
3-Way Junction (90°)
2.
Junction
After making sure all of the screws are engaged in the keyholes, tap the top of the
650w/1050w (module dependent) side panel (A-1) with a cushioned mallet to fully engage. Tie
the 650w/1050w (module dependent) side panel (A-1) and the 2-way junction (B-1) together
using a bottom connector link (Z). Insert this over one of the levellers (between the nut and the
bottom of the panel/junction) in the hooked slot and pivot around to insert the other leveller into
the straight slot. Fully tighten both nuts using a 13mm spanner to trap the connector (Z). You
have fully assembled sub-assembly A. Safely secure this assembly until step 7.
4.
Tap the top of the 650w/850w (module dependent) back panel (C-1) with a cushioned
mallet to fully engage as shown above.
Tie the 650w/850w (module dependent) back panel (C-1) to the 3-way junction (D)
using a bottom connector link
as shown above (see step 2 for method).
(Z)
Z
Bottom Connector Link
Panel
Connector
M8 nut
Leveller
Z
Bottom Connector Link
DWG No: SASS-0040
Revision: B (09/12/15)
Drawn by: Jkb
Drawn date: 06/01/15
Advertisement
