Page 1
Assembly Instructions DEN.Curve 1 Person SASS-0065 A...
Page 2
Stabiliser Foot (Half) Bottom Connector Link Worksurface Components Den.Curve Worksurface M6x20 Button Head Bolts Small Worksurface Fixing Bracket Tools Cushioned Mallet 13mm Spanner 4mm Allen Key/Phillips Screwdriver DWG No: SASS-0065 DEN.Curve Assembly Instructions Revision: A (27/10/15) Drawn by: JB Drawn date: 13/07/15...
Page 3
Small Worksurface Fixing Bracket IMPORTANT: These assembly instructions use a LEFT HAND unit for illustration. To build a RIGHT HAND unit, please mirror the proceeding steps. DWG No: SASS-0065 DEN.Curve Assembly Instructions Revision: A (27/10/15) Drawn by: JB Drawn date: 13/07/15...
Page 4
1 for method). Tie the 650w back panel (C) to the 2-way junction (B) using a bottom connector link (Z). (see step 2 for method). DWG No: SASS-0065 DEN.Curve Assembly Instructions Revision: A (27/10/15) Drawn by: JB Drawn date: 13/07/15...
Page 5
750mm worksurface height (see above). When fixing the brackets to the structure, make sure to pass the machine screws through the 7mm hole and not the slot. DWG No: SASS-0065 DEN.Curve Assembly Instructions Revision: A (27/10/15) Drawn by: JB Drawn date: 13/07/15...
Page 6
If adjusting levellers with a bottom connector link (Z) attached, make sure the nut is fully tightened up to the link (Z) after adjustment of the leveller height. DWG No: SASS-0065 DEN.Curve Assembly Instructions Revision: A (27/10/15) Drawn by: JB Drawn date: 13/07/15...