Advertisement
17.
Attach the 650w/850w (module dependent) back panel (C-2) of sub-assembly C to
the 3-way junction (D) (see step 1 for method).
19.
FRONT
BACK
Using the allen key, attach the worksurface fixing brackets (X&Y) in the positions shown above - leaving them loose at this stage. Each small bracket (Y) uses 1x M6x20mm socket
button head machine screw (W) and each large bracket (X) uses 2 xM6x20mm socket button head bolts (W). Use the top holes/slots for a 730mm worksurface height and the
bottom for a 750mm worksurface height.
When fixing the small brackets (Y) to the structure, make sure to pass the bolts through the top 7mm hole and not the slot.
DEN.Booth Assembly Instructions
Sub-assembly C
250
C L
FRONT
BACK
18.
Tap the top of the 650w/850w (module dependent) back panel (C-2) with a cushioned
mallet to fully engage as shown above. Tie the 650w/850w (module dependent) back panel
(C-2) to the 3-way junction (D) using a bottom connector link (Z) (see step 2 for method).
If fitting worksurfaces continue to step 19.
If fitting seating please see SASS-0102.
X
Large Worksurface
Fixing Bracket
W
W
W
W
4mm Allen Key
X
Y
Small Worksurface
Fixing Bracket
W
M6x20 Button
Head Bolts
W
Small Worksurface
W
Fixing Bracket
Large Worksurface
Fixing Bracket
Y
730mm Worksurface
height
750mm Worksurface
height
DWG No: SASS-0040
Revision: B (09/12/15)
Drawn by: Jkb
Drawn date: 06/01/15
Y
X
Advertisement
