Xyz Jog Operation - Mitsubishi Electric MELFA RH-6SQH Series Instruction Manual

(2) XYZ jog operation

Select XYZ jog mode
<CURRENT> JOINT
J1: +0.00
J2: +0.00
J3: +90.00
J4: +0.00
TOOL JOG
XYZ
Set jog speed
<CURRENT> JOINT
J1: +0.00
J2: +0.00
J3: +90.00
J4: +0.00
TOOL JOG
XYZ
Moving along the base coordinate system
*The direction of the end axis will not change.
・ When the [+X (J1)] keys are pressed, the robot will move along the X axis plus direction.
When the [-X (J1)] keys are pressed, Move along the minus direction.
・ When the [+Y (J2)] keys are pressed, the robot will move along the Y axis plus direction.
When the [-Y (J2)] keys are pressed, Move along the minus direction.
・ When the [+Z (J3)] keys are pressed, the robot will move along the Z axis plus direction.
When the [-Z (J3)] keys are pressed, Move along the minus direction.
◇◆◇ When the robot is in the transportation posture ◇◆◇
There are directions from which linear movement is not possible from the transportation posture. In this case, the
robot will not move. Refer to section "(1) JOINT jog operation" on page 32", and move the robot to a position
where linear movement is possible, and then carry out XYZ jog.
100% M1 T0
J5: +0.00
J6: +0.00
:
:
3-XYZ CYLNDR
⇒
XYZ jog mode
100% M1 T0
J5: +0.00
J6: +0.00
:
:
3-XYZ CYLNDR
⇒
Setting the speed
＋X
[JOG] Press the key and display the jog screen.
("JOG" is displayed on the screen bottom)
Check that the "XYZ" in jog mode is displayed on
the screen.
If other jog modes are displayed, please press the
function key corresponding to the "XYZ." (If the
jog mode which he wishes under the screen is not
displayed, it is displayed that the [FUNCTION]
key is pressed)
If it finishes jog operation, press the [JOG] key
again, or function key which correspond to
"close."
Whenever it presses the key of [OVRD ↑ ], the
override goes up. Conversely, if the [OVRD ↓ ]
key is pressed, it will go down.
The current setting speed is displayed on screen
upper right, and "STATUS NUMBER" of the
controller.
Set the override to 10% here for confirmation
work
＋Z
－X
－Y
＋Y
－Z
2 Unpacking to Installation
＋Z
－Y
＋Y
＋X
－Z
Confirming the operation 2-34
－X