Mitsubishi Electric MELFA RH-6SQH Series Instruction Manual page 88

5 Maintenance and Inspection
<TOOL>
J1:( 1 )J2:(
J4:( 0 )J5:(
J7:( 0 )J8:(
REL. 123
<ORIGIN> TOOL
CHANGE TO ORIGIN. OK?
Yes
123
<TOOL>
J1:( 1 )J2:(
J4:( 0 )J5:(
J7:( 0 )J8:(
REL.
◇◆◇ Release the brake ◇◆◇
Do cursor movement into the parenthesis of each axis by the arrow key. The brakes can be released only for
the axis for which a "1" is displayed on the screen. If the brakes are not to be released, press the [0] key and
display a "0". If the [F1] key on the teaching pendant or the enabling switch is detached while the brakes are
released, the brakes will be work immediately.
◇◆◇ Select the axis of origin setting ◇◆◇
Do cursor movement into the parenthesis of each axis by the arrow key. The origin is set only for the axis for
which a "1" is displayed on the screen. If the origin is not to be set, press the [0] key and display a "0".
Resetting the origin
5-79
0 )J3:( 0 )
0 )J6:( 0 )
0 )
CLOSE
No
0 )J3:( 0 )
0 )J6:( 0 )
0 )
123 CLOSE
10) Input "1" into the J1 axis. Set "0" to other
～
axes.
11) Press the [EXE] key , and display Confirmation
SPACE
screen.
12) Press the [F1] key , and the origin position is
set up.
13) Setting of the origin is completed.
14) Refer to
in this manual, and record the origin data on the
origin data seal.
"5.5.2ABS origin method" on page 90