Setting The Aspect Ratio - NEC MultiSync UX552 User Manual

Setting the Aspect Ratio

Press the ASPECT button on the remote control to cycle through the options available for the current input signal.
For MP (Media Player), VIDEO
➙ ➙
• FULL ZOOM NORMAL
For DVI, DisplayPort1, DisplayPort2, VGA (RGB), OPTION*
➙ ➙ ➙
• FULL 1:1 ZOOM
* : This function depends on which Option Board is installed in the monitor.
1
* 2 : This input is available when the optional Raspberry Pi Compute Module Interface Board and Raspberry Pi Compute Module are installed.
For VGA (YPbPr), HDMI1, HDMI2
➙ ➙
• FULL WIDE DYNAMIC
Aspect ratio of Unchanged view*
image
4:3
Squeeze
Letterbox
* 2 : Gray areas indicate unused portions of the screen.
1:1: Shows the image in a 1 by 1 pixel format.
ZOOM
• The zoom function increases the image size, which expands the image beyond the active screen area. The parts of the
image outside the active screen area are not shown.
NORMAL
➙ ➙ ➙
1:1 ZOOM NORMAL
2 Recommended selection for picture
aspect*
[NORMAL]
[DYNAMIC]
[FULL]
[WIDE]
ZOOM
, COMPUTE MODULE*
1 2
2
Reproduces the aspect ratio that is sent from
the source.
Expands a 4:3 picture to fill the entire screen
with non-linearity. Some of the outside image
area will be cut off due to expansion.
Fills the entire screen.
Expands a 16:9 letter box signal to fill the entire
screen.
ZOOM
English−35
Description