NEC MultiSync UX552 User Manual page 123

CONTROL MENU
KEY LOCK SETTINGS
MODE SELECT
UNLOCK
ALL LOCK
CUSTOM LOCK
DDC/CI
DisplayPort2, DVI, VGA (RGB)
inputs only
PING
IP ADDRESS
EXECUTE
IP ADDRESS RESET
AUTO DIMMING
AUTO BRIGHTNESS
*2
DVI, DisplayPort1, DisplayPort2,
VGA (RGB), MP, OPTION*
3
inputs only
BACKLIGHT DIMMING
(Not available)
* 2 : The function is available only when connecting the optional sensor unit.
* : When you select [OPTION] for signal input, this function depends on which Option Board installed in the monitor.
3
Prevents the monitor from being controlled by the button on the monitor.
When [ACTIVATE] is selected, all of the settings are activated.


NOTE: • [KEY LOCK SETTINGS] is a function intended only for the buttons of the monitor. This function
does not lock out access to the buttons on the remote control.

•
To activate the control key lock function, press the  button and the  button and hold down
simultaneously for more than 3 seconds. To resume user mode, press the  button and the
 button and hold simultaneously for more than 3 seconds.
Selects the mode [UNLOCK], [ALL LOCK] or [CUSTOM LOCK].
All buttons are available for normal operations.
Locks all buttons on the monitor control panel.
All buttons on the monitor are locked except for the following buttons, which can be individually set to be
locked or unlocked.
POWER: Select [UNLOCK] to be able to use the
are locked. Select [LOCK] to lock the button.
Select [UNLOCK] to be able to control the volume with the + and the - button
VOLUME:
when the button on the monitor is locked. The volume can only be adjusted
within the range set for MIN VOL and MAX VOL.
Select [LOCK] to prevent volume adjustment.
MIN VOL and MAX VOL: The volume buttons are unlocked and the volume level can only be adjusted
within the MIN and MAX range set. VOLUME must be set to [UNLOCK] for this
function.
INPUT: Select [UNLOCK] to be able to use the INPUT/SET button when buttons on the
monitor are locked. Select [LOCK] to lock the buttons.
CHANNEL: Select [UNLOCK] to be able to change channels with the  and the  buttons
when buttons on the monitor are locked. Select [LOCK] to lock these buttons.
ACTIVATE / DEACTIVATE: Select [ACTIVATE] to activate all settings. To return to normal operation,
press the  button and the  button and hold simultaneously for more than
3 seconds.
ENABLE/DISABLE: Turns [ON] or [OFF] the two-way communication and control of the monitor.
Confirm successful connection with the network by communicating with a preset IP address.
Sets an [IP ADDRESS] for sending [PING].
Checks a reply can be sent to the monitor or not from the [IP ADDRESS] by sending [PING].
Resets [IP ADDRESS SETTINGS] back to factory settings.
Adjusts the backlight of the LCD automatically depending on the amount of ambient light.
Adjusts the brightness level according to the input signal.
NOTE: Do not select this function when [ROOM LIGHT SENSING] function is any setting other than [OFF].
English−119
button when buttons on the monitor