YASKAWA A1000 Installation Manual page 12

Motor pg feedback line driver interface

Hide thumbs Also See for A1000:

◆

Installing the Option

Remove the front covers of the drive before installing the option. Refer to the drive manual

for directions on removing the front covers. Cover removal varies depending on drive size.

Shut off power to the drive, wait the appropriate amount of time specified on the

drive for voltage to dissipate, then remove the digital operator (E) and front covers

(D, F).

DANGER! Electrical Shock Hazard. Do not connect or disconnect wiring while the power is on. Before

wiring terminals, disconnect all power to the equipment. The internal capacitor remains charged even after

the power supply is turned off. After shutting off the power, wait at least the amount of time specified on the

drive before touching any components.

Figure 3

YASKAWA ELECTRIC TOBP C730600 37B 1000-Series Option PG-X3 Installation Manual

Figure 3 Remove the Front Covers and Digital Operator

5 Installation Procedure

Table of Contents

L1000a