norix C221-111 Series Assembly Instructions

www.norix.com ● TEL 800 234-4900
Assembly Notes:
Norix is not responsible for any damage due to improper installation. If your shipment does not match the parts list, please contact Norix Customer Service at 800-234-4900.
Norix reserves the right to modify design specifications at any time without an obligation to owners of previously sold products.
___________________________________________________________________________________________________________________________________________________________________________________________________
ITEM QTY. PART NUMBER
A 4 021-002
B 6 021-050
C 6 021-051
D 1 024-003
E 1 025-001
F 1 029-010
G 1 033-203
H 1 051-0060
Step 1:
Place the table top, bottom side up, on a flat protective surface to avoid
scratching the table top.
Attach the table leg to the table top by hand starting the 4, 5/16" x 1 ¼" flat
head screws. After each screw has been started, tighten with the wrench
provided.
Step 2:
Using the Torx wrench provided, remove the 2 outer rows of screws from underneath the
seat where the table will attach to the Beam Seating unit. ALL DESIGNATIONS TO LEFT AND
RIGHT IN THESE INSTRUCTIONS ARE DETERMINED BY VIEWINGTHE PRODUCT FROM THE FRONT.
If you are installing a table to the right side of the Beam Seating unit, remove the last 2 rows
of 3 screws on the right side of the last seat. If you are installing a table to the left side of the
Beam Seating unit, remove the last 2 rows of 3 screws on the left side of the last seat. It is not
necessary to remove all 9 screws from the seat. Three screws should be left in to hold the
seat in place while the table is being attached. Dispose of the 6 screws that were just
removed. Replacement screws with Dri-Loc coating are provided.
Step 3:
Slide the table mounting bracket through the side of the Beam Seating unit. Position the
table mounting plate so that the plate is located underneath the steel plate that the seat is
attached to. Attach the table plate by hand starting the 6, 5/16" x 5/8" button head screws,
through the table plate and into the seat. Once all 6 screws have been started, tighten with
the wrench provided.
Rev. B - 9/16/14
091-620
Beam Seating End Tables
Assembly Instructions
Model Number
C221-111X
Parts List
DESCRIPTION
Machine Screw, 5/16"-18 X 1-1/4" L, Black Oxide
Machine Screw, 5/16"-18 X 1", Black Oxide
Machine Screw, 5/16"-18 X 5/8", Zinc
Anchor, Secure Bolt, 3/8" X 2-1/2", 5/16-18, Zinc
Lock Nut, 3/8-16, Zinc
Beam Seat Table Plate Right
Beam Seat Table Leg, Glided
Top, Beam Seat, 1618, Plain Top T-Edge 1.5"
Tools Needed
Low RPM Variable Speed
Hammer Drill
3/8" Concrete Drill Bit
Rubber Mallet
Shop Vacuum
Socket Wrench
5/8" or 16MM Socket
Page 1 of 2