norix TNT0300-FL002T Assembly Instruction

www.norix.com ● TEL 800 234-4900
Assembly Notes:
Norix is not responsible for any damage due to improper installation. If your shipment does not match the parts list, please contact Norix Customer Service at 800-234-4900.
Norix reserves the right to modify design specifications at any time without an obligation to owners of previously sold products.
___________________________________________________________________________________________________________________________________________________________________________________________________
PART
ITEM QTY.
NUMBER
A 1 036-T208-XX
B 4 021-156
C 2 029-021
D 6 025-031
E 2 025-009
The Ladder can be fastened to the top
bunk with two screws, and optionally
fastened to the bottom bunk. To fasten
to the bottom bunk, drilling through the
Ladder posts and the lip on the lower
bunk will be required.
1. Assemble (2) 5/16-18 Screws (B) into
the threaded holes in the tabs at the
top of the Ladder (A). Do not tighten
all the way (Fig 1).
2. Hang the ladder over the lip of the
top bunk. If the Ladder is not to be
fastened to the bottom bunk, the two
screws can be tightened at this time
and the installation is complete. If
fastening to the bottom bunk,
proceed with the following steps.
3. Mark the locations on the Ladder
posts for drilling as shown in Fig. 2,
centering the holes as shown.
4. Before drilling, it may help to clamp
the Ladder to the lower bunk. Drill
through the Ladder poles and bunk lip
at the marked locations, using an
11/32" drill bit. Remove the Ladder
and enlarge the holes in the Ladder
only using a 13/32" drill bit. Deburr the
holes if necessary.
Rev. A - 5/23/18
091-944
Titan Floor Ladder
Assembly Instructions
Model Number
TNT0300-FL002T
PARTS LIST
DESCRIPTION
Ladder, Titan Floor, 60"
Screw 5/16"-18 X 1.5" BH, Pin in Torx®, T-40, Blk. Ox.
Nut, Barrel 5/16"-18 X 0.75"L, BH, Pin in Torx® T45, SST
Washer, 3/8" Uss Zinc .437id 1.00od
Washer, Flat, 3/8, 0.438 ID X 1.0 OD, zinc
A
Lower
Bunk
B
Center hole on Ladder pole
1.0
With ladder in desired position,
mark centers of hole locations.
Fig. 2
Tools Needed
Low RPM Variable Speed
Drill
Pin-in-Torx® driver T40
Pin-in-Torx® driver T45
11/32" Drill Bit
13/32" Drill Bit
Fig. 1
Ladder
Page 1 of 2