norix ATN101-XXX.3 Assembly Instructions

www.norix.com ● TEL 800 234-4900
Assembly Notes:
Norix is not responsible for any damage due to improper installation. If your shipment does not match the parts list, please contact Norix Customer Service at 800-234-4900.
Norix reserves the right to modify design specifications at any time without an obligation to owners of previously sold products.
___________________________________________________________________________________________________________________________________________________________________________________________________
ITEM
PART NUMBER QTY
NO.
A 001-350
B 025-010
C 025-006
D 029-021
E 029-132
F 026-002
G 029-022
H 029-940
I 025-009
1. Place the bed on a protected surface, with the bottom facing
upward. Place the Enclosure Plate (A) on the bed. Mark 14 positions
through the holes in each of pockets.
2. Using an11/32" Drill Bit, drill the 14 holes in the Enclosure Plate.
NOTE: The Restaint Rings can be located in any position on the bed.
however, recommended locations are shown in (Fig.1)
3. Install 6 Restraint Rings (E) in the pockets. Top of rings should point
outward as shown (Detail A). Install 6 barrel nuts (D) through the
restraint rings.
4. Glide assemblies without Restraint Rings are to be located at
positions indicated by "A" (Fig.1). Restraint Ring/Glide assemblies
should be located at "B" positions.
5. Assemble the components in the sequenece shown
in (Fig.2).
Detail A
Rev. A - 9/20/17
091-901
Restraint Ring/Glides Kit
With Enclosure Plate
Assembly Instructions
PARTS LIST
DESCRIPTION
1 Plate, Enclosure, Attenda Bed, 84.50" X 40.50"
14 Nut, Hex, 5/16-18 Steel, Zinc
14 Washer, Lock, Split, 3/8, Zinc
14 Nut, Barrel 5/16"-18 X 0.75"L, BH, Pin in Torx® T45, SST
6 Ring, Restraint, Solid Bolt Down, (Optional)
14 Washer, Fender, 11/32" ID x 1-1/4" OD x .050 Zinc
8 Glide 5/16"-18 X 1.5" Hex Collar Stem
6 Glide 5/16"-18 X 2" Hex Collar Stem
8 Washer, Flat, 3/8"
G
B
C
F
E
D
Model Number
ATN101-XXX.3
A
A
"B" Positions
Fig.2
Tools Needed
11/32" Drill Bit
B B A
B B
A
Fig.1
"A" Positions
T40 Driver
T45 Driver
B
A
A
A
B A
H
A
B
C
F
I
D
Page 1 of 1