norix C221 Series Assembly Instructions

www.norix.com ● TEL 800 234-4900
Assembly Notes:
Norix is not responsible for any damage due to improper installation. If your shipment does not match the parts list, please contact Norix Customer Service at 800-234-4900.
Norix reserves the right to modify design specifications at any time without an obligation to owners of previously sold products.
___________________________________________________________________________________________________________________________________________________________________________________________________
ITEM QTY. PART NUMBER
A 4 021-002
B 12 021-050
C 12 021-051
D 1 029-009
E 1 029-010
F 1 033-203
G 1 051-0050
Step 1:
Place the table top, bottom side up, on a flat protective surface to avoid scratching the
table top. Attach the table leg to the table top by hand starting the 4, 5/16" x 1 ¼" flat
head screws. After each screw has been started, tighten with the wrench provided.
Step 2:
Using the Torx wrench provided, remove the 2 outer rows of screws from underneath
each seat where the table will attach to the Beam Seating unit. ALL DESIGNATIONS TO
LEFT AND RIGHT IN THESE INSTRUCTIONS ARE DETERMINED BY VIEWING THE PRODUCT FROM
THE FRONT. If you are installing a table to the right side of the Beam Seating unit, remove
the last 2 rows of 3 screws on the right side of the last seat. If you are installing a table to
the left side of the Beam Seating unit, remove the last 2 rows of 3 screws on the left side of
the last seat. It is not necessary to remove all 9 screws from the seat. Three screws should
be left in to hold the seat in place while the table is being attached. Dispose of the 12
screws that were just removed. Replacement screws with Dri-Loc coating are provided.
Rev. B - 9/22/14
091-623
Beam Seating Corner Tables
Assembly Instructions
Parts List
DESCRIPTION
Machine Screw, 5/16"-18 x 1-1/4", Black Oxide
Machine Screw, 5/16"-18 x 1", Black Oxide
Machine Screw, 5/16-18 x 5/8, Zinc
Beam Seat Table Plate Left
Beam Seat Table Plate Right
Beam Seat Table Leg, Glided
Top, Beam Seat, Corner, 2929 Plain Top T-Edge 1.5" Thick
Model Number
C221-XXXX
Tools Needed
Low RPM Variable Speed Drill
3/8" Concrete Drill Bit
Rubber Mallet
Shop Vacuum
Socket Wrench
5/8" or 16MM Socket
Page 1 of 2