Initial Checkout Procedure; Configuring The System For Initial Checkout; Initial Power-Up - Banner EZ-SCREEN SLSP14-450Q88 Instruction Manual

Table of Contents

Advertisement

Individual Cordsets
A
Key
Description
A
Emitter
B
Receiver
C
QDE-8..D Cordsets

4.3 Initial Checkout Procedure

The initial checkout procedure must be performed by a Qualified Person. It must be performed only after configuring the System and
after connecting the emitter and receiver.
The procedure is performed on two occasions:
To ensure proper installation when the System is first installed
To ensure proper System function whenever any maintenance or modification is performed on the System or on the machinery
that is guarded by the System.

4.3.1 Configuring the System for Initial Checkout

For the initial checkout, the EZ-SCREEN Type 2 System must be checked without power available to the guarded machine. Final interface
connections to the guarded machine cannot take place until the light screen system has been checked out. This may require lockout/
tagout procedures (refer to OSHA1910.147, ANSI Z244-1, ISO 14118, or the appropriate standard for controlling hazardous energy). The
OSSD connections will be made after the initial checkout procedure has been successfully completed.
Verify that:
Power has been removed from (or is not available to) the guarded machine and its controls or actuators
The machine control circuit or the Safety/Interface Module is not connected to the OSSD outputs at this time (permanent
connections will be made later)

4.3.2 Initial Power-Up

1. Inspect the area near the light screen for reflective surfaces, including work pieces and the guarded machine. Reflective
surfaces may cause light beams to reflect around a person in the light screen, preventing the person from being detected and
not stopping the machine motion (see
B
C
Bn
+24V dc
Or/Bk
n.c.
Or
n.c.
Wh
OSSD2
Bk
OSSD1
Bu
0V dc
Gn/Ye
Ground
Vi
Reset/Test & EDM
Adjacent Reflective Surfaces
www.bannerengineering.com - Tel: 763.544.3164
Splitter Cordsets
A
Key
Description
A
Emitter
B
Receiver
C
DEE2R.. Cordsets
D
CSB.. Cordsets
on page 16).
®
EZ-SCREEN
Type 2 Light Screen
B
C
D
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ez-screen slsp30-1050q88Ez-screen slscr30-300q8

Table of Contents