Table of Contents
Advertisement
UART Mode Select
This item allows you to determine which InfraRed(IR) function of the onboard I/O chip, this
functions uses.
IrDA Duplex Mode
This field is available when UART Mode is set to either ASKIR or IrDA. This item enables you
to determine the infrared function of the onboard infrared chip. The options are Full and Half
(default). Full-duplex means that you can transmit and send information simultaneously.
Half-duplex is the transmission of data in both directions , but only one direction at a time.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that Provides Standard, ECP,
and EPP features. It has the following option:
Disabled
(3BCH/IRQ7)/
(278H/IRQ5)/
(378H/IRQ7)
Parallel Port Mode
SPP :
Standard Parallel Port
EPP :
Enhanced Parallel Port
ECP :
Enhanced
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port only, choose "SPP." To
operate the onboard parallel port in the EPP modes simultaneously, choose "EPP." By
choosing "ECP", the onboard parallel port will operate in ECP mode only. Choosing
"ECP+EPP" will allow the onboard parallel port to support both the ECP and EPP modes
simultaneously. The ECP mode has to use the DMA channel, so choose the onboard parallel
port with the ECP feature. After selecting it, the following message will appear: "ECP
Mode Use DMA" at this time, the user can choose between DMA channels 3 to 1. The
onboard parallel port is EPP Spec. compliant, so after the user chooses the onboard parallel
port with the EPP function, the following message will be displayed on the screen: "EPP
Mode Select." At this time either EPP 1.7 spec. or EPP 1.9 spec. can be chosen.
Poweron After Power Failure
This determines the manner when the power recovery after power failure. The setting are: Off,
On.
3-7-2
Onchip IDE Function
IDE DMA transfer access
Primary Master
Primary Slave
Primary Master
Primary Slave
Onchip SATA Controller
Onchip SATA Type
IDE HDD Block Mode
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Line Printer port 0
Line Printer port 2
Line Printer port 1
Com
Port
Phoenix – AwardBIOS CMOS Setup Utility
OnChip IDE Function
Enabled
PIO
Auto
PIO
Auto
UDMA
Auto
UDMA
Auto
Enabled
Native IDE
Enabled
F6:Optimized Defaults
Menu Level >>
F7:Standard Defaults
28
Item Help
Advertisement
Table of Contents
