Integrated Peripherals; Super Io Device - JETWAY HA03 User Manual

Active State Power Management Support
Link Width:
PCI Express slot link bandwidth: x1, x2, x4, x8, x16 lanes.
Slot Power Limit, W:
Please refer above mention.
GPP1/GPP2/GPP5/GPP6
Press Enter and you can modify tow items:Gen2 High Speed Mode and Link Aspm. Please
refer to the above explanation.
3-7

Integrated Peripherals

> Super IO Device
> Onchip IDE Device
> Onchip PCI Device
↑↓→← Move Enter: Select +/-/PU/PD: Value F10:Save ESC: Exit F1:General Help
F5:Previous Values

Super IO Device

Please refer to section 3-7-1
OnChip IDE Device
Please refer to section 3-7-2
OnChip PCI Device
Please refer to section 3-7-3
3-7-1 Advanced I/O Function Setting
Power on By Keaboard
Power on By Mouse
Onboard FDC Controller
Onboard Serial Port 2
UART Mode Select
* Irda Duplex Mode
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
PWROM After PWR-Fail
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system board
and you wish to use it. If you install add-on FDC or the system has no floppy drive, select
Disabled in this field. The settings are: Enabled and Disabled.
Onboard Serial Port2
Select an address and corresponding interrupt for the first and the second serial ports. The
settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
Phoenix – AwardBIOS CMOS Setup Utility
Integrated Peripherals
Press Enter
Press Enter
Press Enter
F6:Optimized Defaults
Phoenix – AwardBIOS CMOS Setup Utility
Super IO Function Setup
Disabled
Disabled
Enabled
3F8/IRQ4
IrDA
Half
378/IRQ7
SPP
3
[OFF]
F6:Optimized Defaults
Menu Level >
F7:Standard Defaults
Menu Level >>
F7:Standard Defaults
27
Item Help
Item Help