Install Memory - JETWAY HA03 User Manual

2-4

Install Memory

This motherboard provides four 240-pin DDR2 DUAL INLINE MEMORY MODULES
(DIMM) socket for DDR2 memory expansion available from minimum memory volume of
128MB to maximum memory volume of
Valid Memory Configurations
Bank
Bank 0, 1 (DIMM1)
Bank 2, 3 (DIMM2)
Bank 4, 5 (DIMM3)
Bank 6,7 (DIMM4)
Total
*DDR2 1066 could only be reached in the case of overclocking.
Recommend DIMM Module Combination
1. One DIMM Module ----Plug in DIMM1
2. Two DIMM Modules---Plug in DIMM1 and DIMM2 for Dual channel function
3. Four DIMM Modules---Plug in DIMM1/DIMM2/DIMM3/DIMM4.
Dual channel Limited!
1 Dual channel function only supports when 2 DIMM Modules plug in either both DIMM1 &
DIMM2or DIMM3 &DIMM4, or four DIMM Modules plug in DIMM1~DIMM4.
2 DIMM1 & DIMM2, or DIMM3& DIMM4 must be the same type, same size, same frequency
for dual channel function.
Install DDR SDRAM modules to your motherboard is not difficult, you can refer to figure
below to see how to install a 240-Pin DDRII 667/DDRII 800/DDRII 1066 SDRAM module.
NOTE! When you install DIMM module fully into the DIMM socket the eject tab should be locked
into the DIMM module very firmly and fit into its indention on both sides.
8.0GB DDRII SDRAM.
240-Pin DIMM
DDR2 667/DDR2 800/ DDR2 1066 *
DDR2 667/DDR2 800/ DDR2 1066*
DDR2 667/DDR2 800/ DDR2 1066*
DDR2 667/DDR2 800/ DDR2 1066*
System Memory (Max 8.0GB)
PCS
10
Total Memory
X1
128MB∼2.0GB
X1
128MB∼2.0GB
X1
128MB∼2.0GB
X1
128MB∼2.0GB
4
128MB∼8.0GB