Table of Contents
Advertisement
44/52
APAS sensor head | Installation
Bosch Rexroth AG, Edition 11.2020, 3 842 565 042
6.7
Disassembling the sensor head from the APAS
assistant
Damage to the sensor head if disassembled under voltage
During disassembly of the sensor head, electrical contacts are
disconnected. If the contacts of the APAS assistant are supplied with
voltage, this may result in damage to the sensor head.
f Only remove the sensor head from the APAS assistant when the APAS
assistant is switched off.
Damage to the sensor head caused by falling
The sensor head is held at the flange of the APAS assistant by the
clamping ring. If the clamping ring is opened, the sensor head may fall
down.
f Hold the sensor head tight while removing the clamping ring.
f In case of overhead assembly and with a sensor head weight > 3 kg,
a lifting tackle has to be used.
1. Hold the sensor head (1) tight and loosen the two hexagon socket
head cap screws ISO 4762-M4x16-8.8 (2) at the clamping ring.
2. Remove the clamping ring (3) and remove the sensor head from the
rotary coupling of the APAS assistant.
NOTICE
NOTICE
Advertisement
Table of Contents
