How To Use Autocheck 3; Programming A New Application Circuit Board - Husqvarna Automower 550 Workshop Manual

• Make sure that Bluetooth
device.
• Switch the product OFF and ON and try again. Refer
to number 1-4 above.

5.5 How to use Autocheck 3

The program's main functions are grouped in a number
of menus:
Home
•
Auto test
•
Manual test
•
Firmware
•
Actions
•
• Log book
Documents
•
Customers
•
Help
•
Settings
•
5.5.1 Home
When the product is connected to Autocheck an
overview is presented in the
Recommended actions are also shown, for example
recommended firmware updates.
5.5.2 Auto test
Auto test is suitable to use for a fast and overall status of
Auto test menu you can select or
the product. In the
deselect tests. All tests run in a sequence after you push
Start Auto test . During the tests there are animations
guiding you what to do.
Auto test the results are presented in a list.
After the
When clicking on a test there is more information
presented on the screen. It is also possible to print a
report of the test result.
5.5.3 Manual test
Manual test you select, start and stop
When using the
the different tests by yourself. The result is shown live
on the screen and there are no test reports available.
Manual test is appropriate to use when you want to test
a specific component and allow it to work for a certain
period.
5.5.4 Firmware
Firmware menu Autocheck updates the product
In the
firmware if necessary.
CAUTION: Always let Autocheck complete a
started programming process. An interrupted
programming can block the motor control circuit
board or the application circuit board.
5.5.5 Actions
Actions menu shows:
The
10 - Autocheck service tool
®
is enabled on your tablet/
Home menu.
Reset : Contains reset functions, for example Reset
•
charge cycles counter and Reset period time . Reset
charge cycles counter should be done when the
product has a new battery.
be done before the product is returned to the
customer (if there is a need to create a new loop
signal between the product and the charging
station).
Unit replacement : Has the functionality to set the
•
product serial number if the application circuit board
is exchanged.
Advanced mower settings : Contains additional
•
Demo mode and Override loop
functions like
detection . It is also possible to get the Security code
from the product.
5.5.6 Log book
Log book contains the Fault memory where, for
The
example, the product's error codes can be found.
5.5.7 Documents
When a product is connected to Autocheck, only the
relevant technical documentation for that model is
shown. It is however possible to uncheck the box for the
connected product and search for all available
documents in Autocheck, for example spare parts lists,
service bulletins, workshop manuals and operator's
manuals.
5.5.8 Customers
In the customer's menu a list of all the customers and
their products is available. The list is only saved locally.
It is possible to import, export and merge customer lists.
This can be used if you have a number of computers in
your organization.
5.5.9 Help
Here you can find more information about how to use
Autocheck. There are also Frequently Asked Questions
(FAQ), instructional videos and release notes.
5.5.10 Settings
Here you can enter dealer information, change
language, set date format and unit format. To apply the
new language or time format Autocheck must to be
restarted.
5.6 Programming a new application circuit
board
If the application circuit board is replaced, the new
application circuit board must be programmed. The
application circuit board includes information about the
product's serial number.
Note: A new application circuit board may for safety
reasons only be assigned one serial number which is
never changed. It is therefore very important that the
new application board gets the correct serial number.
Reset period time should
1541 - 001 -