To Replace The Front Joysticks - Husqvarna Automower 550 Workshop Manual

5. Clean fully around the mounting surfaces.
6. Attach the new filter. Make sure that the adhesive
surfaces attach correctly to the chassis.
7. Install in opposite sequence.

6.13 To replace the front joysticks

1. Remove the body. Refer to
the body on page 13 .
2. Remove the upper chassis. Refer to
install the upper chassis on page 14 .
3. Remove the 3 screws that holds the front collision
brackets to the chassis.
4. Remove the 3 screws that holds the bracket to the
joystick.
18 - Repair instructions
To remove and install
To remove and
5. Remove the stud (13 socket wrench).
6. Remove the washer and the bellows.
7. Replace the joystick or bellows.
8. Make sure that the nut is in position in the joystick.
9. Install the bracket.
10. Install the bellows and make sure that the bellows
seal around the retainer.
11. Install the washer and make sure it is in position with
the keys to seal correctly.
12. Install the upper chassis and the body in opposite
sequence.
1541 - 001 -