To Mount Screws; To Remove And Install The Body - Husqvarna Automower 550 Workshop Manual

6.1.4 The lower chassis
The lower chassis is structured mechanically around the
modules that follow:
1
2
1. Lower chassis
2. Front wheels
3. Rear wheels
Note: There is a sealing strip between the upper and
lower chassis. Always replace the sealing strip when the
product is opened.
6.1.5 The cutting system
The cutting system is structured mechanically around
the modules that follow:
1
1. Height adjustment motor
2. Cutting motor
3. Blade disc

6.2 To mount screws

It is important to mount the screws correctly. Incorrect
mounted screws may harm the product. The screw
dimension is Torx 20 when there is no other information.
Note: Read the section about how to mount screws in
plastic before starting any maintenance. Refer to
mount screws in plastic on page 31 .
1541 - 001 -
Note: Always use the recommended torque to mount the
screws. Refer to

6.3 To remove and install the body

3
CAUTION: Pull the connector. Do not pull the
cable.
CAUTION: Clean dirt and grass from the
product before you remove the parts.
1. Set the Main switch to
2. Clean the area around the grommets.
3. Pull out the rubber grommet and disconnect the
charge cable.
2
3
4. Pull out the rubber grommet and disconnect the light
cable.
5. Pull out the rubber grommet and disconnect the
ultrasonic cable.
To
Screw fasteners on page 35 .
0 .
Repair instructions - 13