9- Assemblies And Diagrams - Benchmark Games BLASTER Manual

-------------------------------------------------------------------------------------------------------------------------
HOW TO CHANGE THE CHANNEL OF EACH ZIGBEE BOARD:
-------------------------------------------------------------------------------------------------------------------------
Before boards can be game-synched, they need to be on the same frequency channel (1 to 16).
Note: However, the default channel is #15 for all boards upon initial programming.
1- put a jumper on PRG terminal, at this point the LED light will flicker quickly and you will have 2
seconds to start pressing the button
slowly, counting up to the channel number desired for the board (1 to 16). Each press will give you
additional time to continue.
2- When finished pressing, the board will continue flickering for a couple of seconds, then it will start
flashing slowly,
it will flash thru to the number of the channel (i.e. channel 15 ->15 flashes).
3- A couple of seconds after the last flash is done, normal heartbeat flashing will resume, done.
4- Now remove the jumper from the PRG terminal.
(NOTE:The only exception is for the SolarEclipse pie radio, it needs a jumper permanently (so it uses
uart2 instead of 485 line) )

9- Assemblies and Diagrams

Target Assembly
38